Water Filter Replacement - FLAVIA Creation 200 Manuel D'utilisation

W A T E R F I L T E R R E P L A C E M E N T
Your Brewer is fitted with a Water Filter to ensure the water used in brewing your beverages is of
optimal quality. To maintain the quality of beverages brewed, while protecting and extending the life of
your Brewer, you will need to replace this filter periodically. The frequency of replacement depends
on the number of drinks brewed.
The recommended replacement frequency is approximately every 800 beverages or three months
whichever comes first.
Note At the top of the water filter cartridge there is a rotating 'date cap' which may be set to
serve as a reminder of the anticipated replacement date
70 oz
Step 4 If the Brewer is set to 'Manual Fill' operation, ensure that the Brewer is filled with water up to
the 'MAX' level, to ensure that there is enough water in the Brewer to complete the 'Flush' cycle.
Step 5 Turn the Brewer off. Press and hold the 'HOT WATER' and 'LARGE CUP' buttons.
Turn the Brewer back on whilst continuing to hold the two buttons whilst the Brewer powers up.
After the Brewer has powered up, release the two buttons, the 'CALL OPERATOR' symbol
'HOT WATER' button will now illuminate.
Now Press the 'HOT WATER' button to begin the FLUSH cycle.
The Brewer will start to pump water, and after several seconds water will be dispensed into the
container. The water jet may be seen to 'splutter' for a short while at the start, this is normal.
If needed, the Flush cycle can be paused and re-started by pressing the 'HOT WATER' button.
The Brewer will automatically stop pumping after about 2 minutes after which the Flush cycle is
complete. The Brewer will pump approximately 60 fl oz (1.7L) of water into the collecting container.
The system is now Flushed and will begin to heat the water. The 'PLEASE WAIT' symbol
while the water heats. When complete the 'Drinks Selection' lights will illuminate.
Your Brewer is now ready to continue making drinks.
Step 3
The new filter will need to be 'Flushed'. Remove the drip tray
from the Brewer and place a large container in the dispense
area.
13
Step 1
Remove the water filter covers to
access the water filter. Remove the
filter by turning it counter-clockwise.
Discard the used filter
Step 2
Insert the replacement filter and rotate
it clockwise to engage with the
bayonet fitting inside the cold water
reservoir. Replace the water filter
covers.
and
will flash