Motorola L6Q Guide D'installation page 46

MN010089A01-AE
Chapter 2: Pre-Installation
Descriptive camera names should reflect the location and direction of the camera. For example:
● 32nd Ave NB @ Nelson St.
● Windermere HOA West @ Ashwell Ln.
● 5th St Garage, Entrance.
b. Tap to select Deployment Information.
a. Tap to select the Network this camera will use, Wi-Fi or LTE.
13. If necessary, tap Change to set the address and position of the camera in the Set Camera Location
screen.
a. Optional: Enter a partial or full address in the address field to move the map to that area.
b. Tap and drag the map to position the camera.
c. Tap and drag the square to set the direction that the installed camera will face.
d. Tap Set Location.
14. Tap Next.
15. Select from the following options:
If...
If the Wi-Fi Network
option was selected,
If the LTE Network
option was selected,
16. Select one of the four power options:
● If this installation will not use an external power source, tap Internal Battery Only.
● If this installation will use a solar deployment, tap Solar Panel.
● If this installation will use the 120V AC Power Adapter, tap AC 120v External Power.
● If this installation will use the 12V DC Power Cable, tap DC 12v External Power.
17. Observe the pre-installation checklist and ladder safety information, and tap Continue`.
46
Then...
a. Select the local Wi-Fi network SSID to connect to.
b. Enter the Wi-Fi network's password.
c. Tap Next.
a. Select the SIM card that is inserted into the camera:
● Motorola Solutions SIM
● Non-Motorola Solutions SIM
b. If Non-Motorola Solutions was selected, select the service provider
that issued the SIM card.
c. Tap Next.