Motorola L6Q Guide D'installation page 38

MN010089A01-AE
Chapter 2: Pre-Installation
2.5.1
Installing a SIM or SD Card
The MicroSIM and MicroSD card slots are located in the battery compartment of the camera.
Prerequisites: Obtain one or both:
● MicroSD Card
● MicroSIM Card
Procedure:
1. If the Battery Tray is inserted, remove it from the camera.
The camera is shipped without the battery tray inserted.
2. Identify the card slot types and proper card orientations.
Refer to the labels by each slot in the battery compartment.
Figure 7: MicroSIM and MicroSD Cards
3. Orient the card as indicated by the label and slide the card into the correct slot.
4. Press gently on the card until it clicks into place.
CAUTION: Do not forcefully insert the card into the slot. Doing so may damage the card or the
slot. If the card does not slide in easily, re-check the card orientation and slot type.
5. To remove a card, press gently until it clicks out of place.
2.6
Installing the Camera Batteries
The camera is powered by two internal Camera Batteries that are inserted into the Battery Tray. If needed,
the individual batteries or the whole Battery Tray can be swapped out before or after installation. Install the
Camera Batteries before attempting to power the camera from one of the available power options.
Prerequisites: Obtain:
● L6Q Camera
● Camera Batteries
● Battery Tray
● Pin and Torx Tool
38