Motorola L6Q Guide D'installation page 42

MN010089A01-AE
Chapter 2: Pre-Installation
Option Actions
To use perform the following actions:
the AC
a. Align the elbow connector with the lower power port on the back of the camera
Power
Adapter,
b. Tighten down the locking sleeve.
c. Plug the wall plug into an AC outlet.
2. Allow the internal Camera Batteries to fully charge.
During normal camera operation, the LED Status Indicator will appear solid green when the battery is
fully charged. For other LED power indications, see
3. Select one of the following options:
● If this is a Solar Panel deployment, go to
● If this deployment uses an other power option, go to
page 43.
Postrequisites: The internal Camera Battery is fully charged and the LED Status Indicator is solid green.
2.7.2
Charging Solar Panel Batteries
Use the included Solar Panel Battery AC Power Adapter to charge the Solar Panel Battery. If the solar
panel deployment calls for two batteries, each must be fully charged. The LED on the Solar Panel Batteries
indicates the charging status.
Prerequisites: Obtain the following:
● Solar Panel Battery AC Power Adapter
● Solar Panel Battery
42
by rotating the connector until it drops into the port.
Figure 10: AC Elbow Connector to Lower Power Port
LED Status Indicator.
Charging Solar Panel Batteries on page
Pairing Cameras to Mobile Companion on
42.