Motorola L6Q Guide D'installation page 37

Number
6
7
8
9
10
11
2.5
SIM and SD Cards
Each L6Q camera requires an active MicroSIM card to upload detections and a MicroSD card to buffer
detections in case of signal loss. A 32 GB MicroSD card is factory installed in each camera. If purchased as
part of a subscription, an active MicroSIM card is also factory installed in the camera.
Changing SIM cards does not require reprovisioning. For Agencies or Sites that choose to provide their own
SIM card, L6Q cameras support the following mobile carriers:
● Verizon Mobile
● AT&T Mobile
● FirstNet Mobile
CAUTION: A consumer grade SIM card that is not configured for use with L6Q cameras will incur
excessive voice billing charges from the carrier! Voice charges are considered legitimate and cannot be
disputed. Only approved Internet of Things (IoT) SIM cards configured for L6Q data should be used
with the L6Q camera. Contact Vigilant Support for questions regarding cellular carriers and approved
SIM cards.
Option
Update Location
Re-aim Camera
Relocate
Deactivate
Delete
Continue Installing Camera
MN010089A01-AE
Chapter 2: Pre-Installation
Description
Opens the Location map to
change the address and aiming
direction of this installed camera.
● Pinch to zoom in or out, or
drag the map to position the
camera.
● Press and drag the square to
rotate the direction the cam-
era is facing.
Begins the aiming process for
this camera.
Begins the relocation process for
moving this camera to a new in-
stallation site.
Temporarily pauses this camera
from capturing and sending de-
tections, without deleting it.
Deletes this camera from the
application and VehicleManag-
er/ClientPortal. Deleted cameras
will need to be paired again and
reinstalled from the application
to be restored.
Continues a paused installation
from the last completed step.
37