Télécharger Imprimer la page

Motorola L6Q Guide D'installation page 39

Publicité

Les langues disponibles

Les langues disponibles

Procedure:
1. Ensure that the camera is disconnected from any external power source.
NOTE: Connecting power to the camera before installing the Camera Batteries will prevent
them from charging.
2. Remove and discard any foam or shipping material from between the battery slots in the battery tray.
3. Install the Camera Batteries into the battery tray:
a. Orient one of the Camera Batteries so that the gold contacts are facing up and towards the center
of the Battery Tray.
b. Slide the battery into one of the Battery Tray slots.
c. Repeat for the other Camera Battery.
When the Camera Batteries are properly installed, the gold contacts will be facing each other.
4. Install the Battery Tray into the camera:
a. Extend the security screws on the Battery Tray.
b. Hold the camera in the upright position.
c. Orient the Battery Tray with the arrow facing towards the front of the camera.
The front of the camera is the side with the camera lens, opposite the mounting ball.
d. Slide the Battery Tray into the battery compartment.
CAUTION: If the battery tray is backwards, it will not slide into the compartment. Do not
force the Battery Tray into the battery compartment.
e. Press firmly on the battery tray to seat it into the camera.
f.
Check that the battery tray is flush with the camera housing.
This will ensure that the camera is resistant to dust and water ingress.
g. Tightly secure the two security screws with the Pin and Torx Tool.
Figure 8: Battery Installation
2.7
Battery Charging
The internal Camera Batteries must be fully charged before proceeding with Hardware Installation. For solar
panel deployments, the Solar Panel Batteries must also be fully charged. Charging all batteries at the same
time is recommended, as they have similar charging times.
NOTE: Failure to fully charge the Camera Batteries and Solar Panel Batteries before installation may
cause the batteries to die before there is sufficient power to keep them charged under load.
MN010089A01-AE
Chapter 2: Pre-Installation
39

Publicité

loading