Nicotra Gebhardt RegalRexnord COPRA P/C-25 Mode D'emploi page 11

O I C O P R A T M F A N S C / P 1 . 2
Appendix
Original
EC declaration of incorporation
for the EC Machinery Directive (2006/42/EC)
The manufacturer:
Gebhardtstraße 19-25, 74638 Waldenburg, Germany
hereby declares that the following product:
Product designation:
Type designation:
Serial number:
Year of manufacture:
as a partly completed machine in the sense of Article 2, clause "g" meets
the following basic requirements of the Machinery Directive (2006/42/EC):
Appendix I, Articles 1.1.2, 1.3.7
This partly completed machine may only be commissioned once it has been
determined that the machine into which it is to be fitted complies with the
provisions of the Machinery Directive (2006/42/EC).
The following harmonised standards 1) were applied:
DIN EN ISO 12100: Safety of machinery – General principles for design
DIN EN ISO 13857: Safety of machinery – Safety distances to prevent hazard
zones being reached by upper and lower limbs
Additional national standards and technical specifications 2), in particular:
VDMA 24167: Fans – Safety requirements
The manufacturer is committed to providing the special documents required
for the partly completed machine as per Appendix VII, Part B to any national
authority on request by post/e-mail.
Waldenburg/Ciserano, June 01, 2023
Authorised representative for the technical documentation: Klaus Gundel
Production Director / Production Director / Head of Research and Development
pp. Ulrich Reichert / pp. Paolo Di Dionisio / pp. Dr. J. Anschütz
1) Please refer to the documentation provided by the manufacturer for a complete list of
applicable standards and technical specifications
2) Insofar as no corresponding harmonised standards are yet available
Nicotra Gebhardt GmbH
Radial fan without housing with
direct drive
COPRA CB-C..., COPRA PA-C...
See type plate
See type plate
Original
EC declaration of conformity
for the European Ecodesign Directive (2009/125/EC)
We hereby declare that the product stated below complies with the
ecodesign requirements, as stipulated by Regulation (EU) No, 327/2011 of the
Commission in Appendix I, Section 2, based on the degree of efficiency of
the corresponding fan type specified in the technical documentation and the
measurement/efficiency category.
Designation:
Fan type:
Device number:
Year of manufacture:
Relevant EC Directives:
Waldenburg/Ciserano, June 01, 2023
Production Director / Production Director / Head of Research and Development
pp. Ulrich Reichert / pp. Paolo Di Dionisio / pp. Dr. J. Anschützz
Original
EC declaration of conformity
for the European Electromagnetic Compatibility Directive (2014/30/EU)
for the Eurpean Low Voltage Directive (2014/35/EU)
Herewith we declare that the machinery designated below, on the basis of
its design and construction in the form brought onto the market by us is in
accordance with the relevant EU Council Directives as mentioned below. If
alterations are made to the machinery without prior consultations with us, this
declaration becomes invalid.
Designation:
Fan type:
Device number:
Year of manufacture:
Device Number:
Year of manufacture:
Relevant EC Directives:
Applied harmonized
standards, in particular
The sole responsibility for issuing this declaration of conformity lies with the
manufacturer.
Waldenburg, June 01, 2023
Production Director / Production Director / Head of Research and Development
pp. Ulrich Reichert / pp. Paolo Di Dionisio / pp. Dr. J. Anschütz
*Electromagnetic Compatibility directive according to 2014/30/EU is only
applicable if the listed types and series are installed and commissioned in
accordance with the operating instructions. If the listed types and series
are integrated as system components into a system or operated with other
components such as control or control devices, the operator or manufacturer
of the entire system is responsible for compliance with the directive according
to 2014/30/EU.
© 2023 Regal Rexnord Corporation. All Rights Reserved.
Radial fan without housing with
direct drive
COPRA CB-C..., COPRA PA-C...
See type plate
See type plate
EC Directive on the
environmentally friendly
"ecodesign" of energy-related
products (2009/125/EC)
Radial fan without housing with
direct drive
COPRA CB-C..., COPRA PA-C...
See type plate
See type plate
See type plate
See type plate
EU-Directive of Electromagnetic
Compatibility (2014/30/EU)
Low Voltage Directive (2014/35/EU)
DIN EN 60335-1, DIN EN 60204-1
DIN EN 61000-3-2, DIN EN 61000-3-3
DIN EN 61000-6-2, DIN EN 61000-6-4
DIN EN 61000-4-3, DIN EN 61000-4-6
DIN EN 61000-4-13
XXXXXXXXXX • Format# XXXXXX R1
E N
11