Publicité
Les langues disponibles
Les langues disponibles
Cleaning the motorcycle
To preserve the finish of metal parts and paintwork, wash
and clean your motorcycle at regular intervals, anyway
according to the road conditions you ride in.
Use specific products only. Prefer biodegradable
products. Avoid aggressive detergents or solvents.
Important
Do not wash your motorcycle right after use. When
the motorcycle is still hot, water drops will evaporate
faster and spot hot surfaces.
Do not use high-pressure or hot water jets. Using water
cleaners could cause certain parts - such as front fork,
wheel hubs, electric system, front fork seals, air scoops
and exhaust silencers - to seize or malfunction and impair
the safety features of the motorcycle.
Clean off stubborn dirt or exceeding grease from engine
parts using a degreasing agent. Be sure to avoid contact
with drive parts (chain, sprockets, etc.)
Rinse with warm water and dry all surfaces with chamois
leather.
Warning
Braking performance may be impaired immediately
after washing the motorcycle.
Never grease or lubricate the brake discs. Loss of braking
and further accidents may occur.
Clean the discs with an oil-free solvent.
Storing the bike away
If the motorcycle is to be left unridden over long periods,
it is advisable to carry out the following operations before
storing it away:
clean the motorcycle;
remove tank drain plug and seal and drain all fuel from
tank;
pour a few drops of engine oil into the cylinders through
the spark plug seats, then crank the engine by hand a
few times so a protective film of oil will spread on
cylinder inner walls;
place the motorcycle on the paddock stand;
disconnect and remove the battery. Battery should be
checked and charged whenever the motorcycle has been
left unridden for over a month;
protect the motorcycle with a suitable canvas that will
protect paintwork and let condensate breathe out.
A special canvas is available from Ducati Performance.
E
55
Publicité
