Scheppach HC08 Traduction Des Instructions D'origine page 23

12. Troubleshooting
Fault Possible cause
No supply voltage.
Insufficient supply voltage.
The compressor does
not start.
Outside temperature is too low.
Motor is overheated.
The non-return valve leaks.
The compressor starts
The seals are damaged.
but there is no pres-
sure.
The drain plug for condensation water (11)
leaks.
The hose connections have a leak.
The compressor
starts, pressure is
A quick-lock coupling has a leak.
shown on the pressure
gauge, but the tools
Insufficient pressure set on the pressure
do not start.
regulator (16).
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
All manuals and user guides at all-guides.com
Remedy
No supply voltage.
Insufficient supply voltage.
Outside temperature is too low.
Motor is overheated.
The non-return valve leaks.
The seals are damaged.
The drain plug for condensation water (11) leaks.
The hose connections have a leak.
A quick-lock coupling has a leak.
Insufficient pressure set on the pressure regula-
tor (16).
GB | 23