Cleaning The Roller Arm And Roller Handle; Maintenance - WAGNER Roll'n Go Guide D'utilisation

Cleaning the roller handle and roller arm
Follow these steps only if you 1) used latex materials, 2) and plan on throwing away the pump and hoses.
1. Remove large hose and small air hose from the roller
handle.
3. To disassemble and clean the roller assembly, insert
thumb to first knuckle, PRY and PULL the cap from the
roller cover. Once the cap is removed, PUSH the core out
the other end. Drop the parts into a bucket or sink filled with
warm, soapy water and clean by hand.
IMPORTANT
The areas on the roller handle indicated below must be
cleaned thoroughly and lubricated after each use. ALL paint
should be removed from the areas highlighted in gray below,
especially the quick-release tabs and all other areas that
connect with other parts. This can be done by using the
appropriate cleaning solution and an old toothbrush (DO NOT
SUBMERGE ROLLER HANDLE).
Quick-release tabs
Connecting area
English
2. Open the base door and remove the pump and suction
hose assembly. You can now dispose of the suction
hose, the pump assembly, and the longer paint hose.
4. Press the quick-release tabs on the handle and separate
the roller arm from the roller handle. Place the connecting
areas of each under a sink running with warm water until all
material is flushed out.

Maintenance

In addition to thoroughly cleaning after every use, you must
CLEAN and LUBRICATE the areas on the roller arm indicated
below. Use a thin layer of petroleum jelly to lubricate the
indicated areas.
8