Using The Handle Button; Priming; Painting; Painting Tips - WAGNER Roll'n Go Guide D'utilisation

1. To start the motor, FULLY PRESS AND RELEASE the handle button.
2. When paint appears through the roller, PRESS AND RELEASE handle
button to shut off the motor and stop the flow of paint.
1) Continuous Flow
The continuous flow method is recommended when you are
painting a large area with the roller.
1. FULLY PRESS AND RELEASE handle button to start
flow of paint.
2. FULLY PRESS AND RELEASE handle button again to
stop flow of paint.
• Always make sure to open a window or door to ensure proper ventilation.
• Make sure the area you are painting has been properly prepared (tape off around floor, window and door moldings and use
drop cloths to protect floors and furnishings). Paint only one surface at a time.
• Pick an area to start where you can saturate the roller cover and evenly distribute the paint. Working in three-foot sections,
begin by cutting-in around windows, doors, cabinets, base and other breaks in the wall surface.
• For best coverage results, start painting at one end of a wall and roll out the letter "W". Fill it in with crosswise strokes,
working your way across the wall in 3' x 3' sections. Finish the sections by painting one solid swipe from ceiling to floor. This
will give you a nice even paint finish.
• Be careful not to over-saturate the roller cover as it may drip, slide on the wall or spatter.
• Make sure to run the roller cover over the areas you cut-in around the trim and baseboards to even out the texture.
• If you need to stop and take a break; finish painting the entire wall, or stop at a break in the wall such as a doorway or corner
to prevent lap marks. During extended break periods, place your roller cover assembly in a plastic bag to keep it from drying
out.
English

Using the handle button

Priming:

Painting (2 methods):

Painting Tips:

2) Stop and Start
The Stop and Start method is recomended when you are
painting a smaller area and wish to have more flow control.
1. PARTIALLY DEPRESS AND HOLD the handle button
until material appears through the roller pad. Material will
continue to flow while button is held in this position.
2. RELEASE BUTTON to stop flow of material.
4