Güde GEH 5000 R Traduction Du Mode D'emploi D'origine page 20

ENGLISH
20
by persons with reduced physical, sen-
sory or mental capabilities or lacking
experience or know-how, provided
they are under supervision or have
been instructed on the safe use of the
apparatus and understand its poten-
tial dangers. Children must not be
allowed to play with the apparatus.
Children are not allowed to carry out
cleaning or user maintenance unless
under supervision.
Children younger than 3 years must be
kept away from the apparatus unless
under constant supervision.
Children aged between 3 and 8 years
are not allowed to switch the appara-
tus on or off unless under supervision
or after instruction on its safe use,
including awareness of potential
hazards, provided also the apparatus
is positioned or installed as for normal
use.
Children aged between 3 and 8 years
shall not plug in or operate the appa-
ratus or clean it and/or carry out user
maintenance.
Caution – certain parts of the product
may get hot enough to cause burns.
Particular caution is called for if child-
ren and persons requiring protection
are present.
CAUTION! To prevent the danger of
inadvertent resetting of the thermal
cut-out relay, the apparatus must not
be supplied via an external contactor
such as a timer switch or be connected
to a circuit that will automatically
switch on and off.
Attention! A damaged cord of this
apparatus must be replaced by the
manufacturer or his customer service
or a similarly qualified person, to pre-
vent hazards.
Flammable materials should be kept
at a safe distance of at least 1 metre
from the apparatus.
Do not use or store explosive or
flammable materials (e.g. fuel, paper,
paints) in the vicinity of the product.
Select a place to install the apparatus
where inadvertent contact can be
prevented.
Keep the heater clean.
Protect the electrical parts from
moisture. To prevent electrical shock,
never submerse these parts in water
or other fluids during cleaning or
when in operation.
Never hold the apparatus under flow-
ing water.
Switch off the apparatus, disconnect
it from mains by unplugging and
allow it to cool down before setting
up, retrofitting, cleaning, performing
maintenance, storing or transporting
the apparatus.
Operation is only allowed
with a safety switch against
stray current (RCD max. stray
current of 30mA).
Always pull the mains plug when the
heater is not in use. Do not tug at the
cable to unplug the apparatus.