Technical Data; Warranty - LOHBERGER LOBO Série Manuel D'utilisation

23. Technical data

Dimensions
Flue gas connection
Combustion air connection
Fuel filling door opening
Fuel filling space
Fuel filling height
Fuel consumption
Heating time max.
Ash drawer
Weight (without packaging)
Output data
Data for chimney calculation (according to EN 13384)
Rated heat output
Flue gas temperature
Flue gas mass flow rate
Required discharge pressure

24. Warranty

These warranty conditions are valid in all European countries
where LoHBERGER appliances are sold by local specialist dealers.
Warranty claims must always be directed to a local LoHBERGER
specialist dealer or the dealer from whom you have bought the
appliance.
Warranty
LoHBERGER grants a 3-year full warranty on verifiable defects in
material or workmanship. Warranty claims will not be accepted in
any case after five years following the manufacture of the appli-
ance.
Certain restrictions apply to some models and parts: for appli-
ances with central heating insert the warranty depends either on
correct specialist installation of a return flow temperature boost or
the installation of a control cabinet (AME.4).
Exceptions
The warranty does not apply to the normal wear and tear on an
appliance used for heating. These parts include for instance:
Fireclay - Changes in colour or expansion cracks due to the heat-
ing process can never be completely ruled out. However, they do
not impair the functioning of the appliance as long as the fireclay
remains in the firebox.
Glass panes (breakage of glass because of external action, chang-
es on the surface due to thermal influences such as partly sintered
fly ash or soot on the surface of the glass front)
Discolouring of paint due to overload or thermal stress
Seals (e.g. hardening or breakage due to thermal or mechanical
stress)
Surface coatings (frequent cleaning or cleaning with abrasive
cleaning agents)
Cast iron parts (Cast parts subjected to high thermal load such as
JETFIRE flame convergence plate and grate)
Pellets - Conveying device Tilting grate, ignition element and tem-
perature sensor of the Lohberger pellet module
Start or Warranty
The start of warranty is the time the appliance is handed over to
the user. Please keep this user manual as well as the warranty card
with the invoice in a safe place at all times. A prerequisite of our
22
Width x height x depth
Diameter
Diameter
Width x height
Width x height x depth
Insert stove
at rated heat output kg / h
at rated heat output
Insert stove Liter
Insert stove
Wood
Wood
Wood
at rated heat output
english
Lobo S Lobo XL
cm 46 x 52,6 x 109,3 46 x 52,6 x 144,2 46 x 49,6 x 109,3 46 x 49,6 x 144,2
cm
cm
cm
cm
cm
h
kg ca. 165-190 ca. 170-205
kW
°C
g/s
Pa
warranty obligation is that the appliance has been installed and
connected according to our instructions and the applicable EN/DIN
/Austrian standards and that it has been operated and correctly
maintained according to our instructions.
Repairs
We will carefully check your appliance and establish whether the
warranty claim is justified. If yes, we will decide in which way the
defect should be corrected. In the event of a repair we will have it
carried out correctly and competently on location or in our works.
This does not affect the start of the warranty determined by the
handover; if it is necessary to replace the appliance, the warranty
period starts anew. If you send in your appliance for repair please
enclose the proof of purchase.
Costs
LoHBERGER accepts all costs for the duration of the warranty.
Should we decide that your appliance is best repaired in our
works, you will bear the transport costs and assume the responsi-
bility for the transport.
Liability Exclusion
We cannot accept any liability for the loss or the damage of an ap-
pliance through theft, fire, vandalism or similar causes. Indirect or
direct damages caused by a supplied appliance or arising from the
delivery of an appliance are excluded from the liability unless the
delivery was performed by LoHBERGER or by a transport company
commissioned by LoHBERGER.
We cannot assume any liability for damages caused by chemical
or electrochemical effects (e.g. pollutants in the combustion air,
condition of heating water not in compliance with the VDI guide-
lines – e.g.: "calcification", etc.) or as a result of installation not in
accordance with the technical regulations or the LoHBERGER docu-
mentation. We will accept liability for visible paint and enamel
damages that can be attributed to manufacturing defects only if
such defects are brought to our attention in writing within 14 days
following the handover of the appliance.
Modifications of the appliance or tampering by persons who are not
authorised by us will invalidate our warranty obligation. Adjustment
and conversion work are subject to billing.
Kesar S
12
10
27,5 x 28,8
31 x 35,5 x 27
ca. 15
ca. 1,9
ca. 1
3,5
ca. 165
7,1
240
7,1
12
Kesar XL
ca. 170