Caution: The Chimney May Become Obstructed; Correct Procedure In The Event Of Chimney Fires; Transport / Unpacking / Inspection; Transport Options - LOHBERGER LOBO Série Manuel D'utilisation

CAUTION: The chimney may become obstructed.

Make sure that the chimney is free from obstructions when the stove
is heated up again after it has been out of use for an extended peri-
od of time. Before re-starting the stove, have the chimney inspected
by a specialist (chimney sweep).

Correct procedure in the event of chimney fires:

If the fireplace, connecting duct and chimney are not regularly
cleaned or if unsuitable fuels are burned, the deposits may ignite,
causing a chimney fire.
Keep the stove doors closed and turn the air regulators to position
„0". Move away combustible components from the chimney. UNDER
NO CIRCUMSTANCES should you attempt to extinguish the chimney
fire by applying water. The suddenly developing steam pressure is
so high that the chimney could burst. --> Call the fire brigade via the
emergency phonenumber.

5. Transport / Unpacking / Inspection

Report visible faults to the supplier immediately.
Later claims for damages cannot be entertained.
The packaging of your appliances provides good protection against
damage in transit. Nevertheless, damage to the appliance and fit-
tings cannot be entirely excluded.
Therefore carefully check the appliance for completeness and pos-
sible damage in transit after unpacking.

Transport options

Transport on pallet
Transport the appliance on the pallet to the installation site. Remove
transport securing safety devices and lift the appliance from the
pallet.
Transport with a trolley
Transporting sideways on a trolley is possible on the rear of the
appliance.
For this, remove the transport securing devices and transport the
appliance to the installation site using the trolley.

Transport safety device

(Fig. „17. Start-up" on page 19)
The appliance is secured by means of transport securing plates
First remove wood screws
plates off.

Checking of loose parts

(Fig. „C" on page 2)
Prior to starting up the appliance for the first time, check whether all
loose parts are in their designated place:
• The upper steel flue baffles
be positioned on the supports as shown.
• The Vermiculite baffle plate
on the supports on the left and right and be pushed to the back
as far as it goes.
• The combustion chamber grate must be located on the rear sup-
port and be flush with the lateral combustion chamber blocks.
16
Fuels
and then take transport securing
35 Important instructions
and
Air supply settings
must be located
english
6. Fitting the stone cover (optional
equipment)
(Fig. „Tab. 2" on page 19)
CAUTION: The stone cover is rally heavy. Therefore at least two per-
sons should carry out the assembly in order to prevent injury or
damage to the appliance or to the stone cover.
1. Lift the steel cover a little at the back...
2. ... and remove it towards the front.
3. Position the stone covering and align it on the appliance.
4. Insert the perforated flue pipe cover.

7. Product description

The stoves type Lobo/Kesar are wood-burning stoves for intermittent
operation. What distinguishes these stoves from stoves for continu-
ous operation is the interval at which fuel is added, and the burn
time of the stove is not limited. You can operate a wood-burning
stove for intermittent operation over lengthy periods of time without
running the risk of damaging the appliance.
The stove body is a welded steel construction. Depending on the
design of the appliance, different materials are used for the cladding.

Components shown

(Fig. „A" on page 2)
1 Steel cover
2 Insert for chimney flue connection
3 Side wall casing Kesar S (shown: steel)
4 Firebox door latch, stove body
5
Drawer runner with tip-on (only with optional firewood storage drawer
6 Firewood storage drawer (optional equipment)
7 Firebox door latch, door
8 Firebox door handle Kesar
9 Firebox door viewing glass
10 Firebox door seal
11 Firebox door body
12 Air slider secondary air
13 Firebox door catch
14 Air slider primary air
15 Grate
16 Ash pan
32
.
20 Panel XL
21 Side wall cladding Lobo XL (shown: enamel /ceramic)
22 Firebox door handle Lobo
23 Door of firewood storage compartment, Lobo
24 Door latch for firewood storage compartment (magnetic catch)
must
)