Using The Ice Maker Without Awater Filter - Jennair W10728796B Guide D'utilisation

GETTING STARTED
TO REMOVE THE GRILLE PANEL FROM THE
REFRIGERATOR:
1.
Open the door(s).
2.
Place both hands under the grille panel,
grasping the bottom edge between your
fingers and thumbs.
3.
Pull the grille panel straight out until the
grille stops. Then, lift up on the grille panel
to remove.
POWER ON OR OFF SWITCH
1.
Remove the top grille panel.
2.
Press power switch to the On or Off
position.
3.
Replace the top grille panel.
IMPORTANT: Be sure the power switch is set to
the On position after cleaning refrigerator or
changing light bulbs.
A. Power switch
USING THE ICE MAKER WITHOUT A
WATER FILTER
You can operate the ice maker without a water
filter. Your ice will not be filtered.
1.
Remove the filter by pressing the eject
button and pulling on the cap. Refer
"Changing the Water Filter" earlier in this
section.
2.
Remove the cap by turning it
counterclockwise until it stops.
IMPORTANT: Do not discard the cap. It is
part of your refrigerator.
3.
With the cap in a horizontal position, insert
the cap into the base grille until it stops.
4.
Turn the cap counterclockwise until the cap
slips into the attachment slot. Then, turn
A
the cap clockwise until it is in a horizontal
position.
NOTE: The cap will not be even with the
base grille.
GETTING STARTED | 15