Changing The Water Filter - Jennair W10728796B Guide D'utilisation

CARE AND CLEANING

CHANGING THE WATER FILTER

The water filter is located in the base grille
below the freezer compartment door. It is not
necessary to remove the base grille to remove
the filter.
1.
Remove the filter by pressing the eject
button and pulling straight out on the filter
cap.
NOTES:
Avoid twisting the cap when removing
the filter because this could cause the
cap to come off. If this occurs, replace
the cap and pull the filter straight out.
There will be water in the filter. Some
spilling may occur.
A
A. Eject button
B. Filter cap
2.
Remove the cap by turning it
counterclockwise until it stops.
IMPORTANT: Do not discard the cap. It is
part of your refrigerator. Keep the cap to
use with the replacement filter.
3.
Align the ridge on the cap with the arrow
on the new filter and turn the cap until it
snaps into place.
20 | CARE AND CLEANING
. A
B
A. Cover
B. O-rings
4.
Remove the covers from the O-rings. Be
sure the O-rings are still in place after the
covers are removed.
5.
Place the cap (removed in Step 2) on the
new filter. Align the ridge on the cap with
the arrow on the filter. Turn the cap
clockwise until it snaps into place.
A
B
A. Eject button
B. Arrow on filter
C. Ridge on cap
6.
Push the new filter into the opening in
the base grille. As the filter is inserted, the
eject button will depress. The eject button
will pop back out when the filter is fully
engaged.
7.
Pull gently on the cap to check that the
filter is securely in place.
8.
Flush the water system. Depending on your
model, refer "Water and Ice Dispensers" or
"Ice Maker and Storage Bin."
B
C