Spypoint LIVE Manuel D'utilisation page 5

8
AA BATTERIES
This camera requires the use of 8 AA batteries (1.5V). The use of
alkaline or lithium batteries is strongly recommended. Also note
that the voltage of rechargeable AA batteries (1.2V) is insufficient
to power this camera. During the installation of the AA batteries,
slide the switch inside the battery case to ALK (i.e. alkaline). Insert
the batteries in the camera as indicated. Exact polarity must be
followed. We also recommend the use of new batteries to ensure
maximum performance of your camera.
LITHIUM BATTERY PACK
The camera can be powered by a rechargeable lithium battery
pack LIT-09/LIT-C-8 (sold separately, see OPTIONS). This type
of battery is less affected by cold temperatures and lasts up to 3
times longer than alkaline batteries. During the installation of the
lithium battery pack, slide the switch inside the battery case to LIT-
09. Insert the battery in the camera as indicated (see figure below).
EXTERNAL
The camera can also be powered from an external 12-volt DC input
such as a 12-volt battery (BATT-12/KIT-12V, sold separately) or a
12-volt adapter (AD-12V, sold separately). During the installation of
a 12-volt connection, slide the switch inside the battery case to ALK
(the AA batteries can remain safely inside the camera). If combined
with a lithium battery pack, slide the switch to LIT-09. For the
accessories available, see OPTIONS.
All manuals and user guides at all-guides.com
RESET
ALK
LIT-09
SOLAR PANEL
This model offers the possibility of a connection to a solar panel
SP-12V (sold separately, see OPTIONS) to maintain the charge
of the lithium battery pack LIT-09/LIT-C-8 (sold separately, see
OPTIONS). During the installation of the rechargeable lithium
battery pack, slide the switch inside the battery case to LIT-09 to
activate the charging system of the solar panel.
Power source
• 8 AA
• 12V
• 12V + 8 AA
• LIT-09
• 12V + LIT-09
• Solar Panel + LIT-09
MEMORY STORAGE
Using a memory card (sold separately, see OPTIONS) is required
to operate the camera. When the PHOTO or VIDEO mode is
selected, the screen displays "No memory card" if no memory card
is present. The camera is compatible with SD/SDHC memory card,
up to 32 GB capacity. Before inserting or removing a memory card,
the camera must be turned off. Failing to do so may cause loss of
pictures or damage the pictures already saved on the memory card.
When the SD card is full, the viewing screen indicates "Memory
card full" when the PHOTO or VIDEO mode is selected. The used
space on the memory card is displayed as percentage in the upper
right corner of the screen when the camera is in TEST mode. The
following data shows the approximate quantity of photos or video
length that can be taken by the camera depending on the memory
card capacity.
2.0 GB
Photo
5 MP 1700
Video
640 x 480 65 min
Switch position
ALK
LIT-09
4.0 GB 8.0 GB 32 GB
3400 6800 27300
2h10 4h10 16h40
9