Publicité
Les langues disponibles
Les langues disponibles
NB: For safety, the gap between the hob and
any cupboard above it should be at least 760
mm.
3. Fix the hob to the worktop using the four
brackets on the base of the hob. The
position of the brackets can be adjusted
according to the thickness of the top.
Bracket
Warnings:
The induction hob must be installed by a
(1)
properly qualified person. We have our
own qualified installers. Never try to install
the appliance yourself.
The induction hob must not be installed
(2)
above refrigerators, freezers, dishwashers
or tumble dryers.
The induction hob should be installed so
(3)
that optimum radiation of heat is possible.
The wall and the area above the hob
(4)
should be able to withstand heat.
To avoid any damage, the sandwich layer
(5)
and adhesive should be heat-resistant.
4. Connection to power supply
The socket should be connected in
compliance with the relevant standard, to a
single-pole circuit breaker. The method of
connection is shown in Figure 3.
Voltage
380-415V 3N~
Black Brown
220-240V~
Black & Brown
Figure (3)
Wire connection
Blue
YeIlow/Green
Blue
YeIIow/Green
If the cable is damaged or needs replacing,
this should be done by an after-sales
technician using the proper tools, so as to
avoid any accidents.
If the appliance is being connected directly to
the mains supply, an omnipolar circuit breaker
must be installed with a minimum gap of 3
mm between the contacts.
The installer must ensure that the correct
electrical connection has been made and that
it complies with safety regulations.
The cable must not be bent or compressed.
The cable must be checked regularly and only
replaced by a properly qualified person.
Diagram of induction hob:
2
1
1. Max. 1500/2000 W zone
2. Max. 1500/2000 W zone
3. Max. 3000/3600 W zone
Schematic diagram of the control panel
1
1.
Heating zone selection controls
2.
Timer regulating key
3.
Keylock/Pause control
EN-6
5
4. Glass plate
5. Control panel
2
3
4. ON/OFF control
4
3
4
Publicité
