Télécharger Imprimer la page

ROSIERES RI633DC/G3 Manuel D'instructions page 5

Plaque à induction

Publicité

Les langues disponibles

Les langues disponibles

Safety
This hob was specially designed for domestic
use.
In its constant search to improve its products,
CANDY reserves the right to modify any
technical, programme or aesthetic aspects of
the appliance at any time.
Protection from over-heating
A sensor monitors the temperature in the
cooking zones. When the temperature
exceeds a safe level, the cooking zone is
automatically switched off.
Detection of small or non-magnetic
items
When a pan with a diameter of less than 80
mm, or some other small item (e.g. knife,
fork, key) or a non-magnetic pan (e.g.
aluminium) has been left on the hob, a
buzzer sounds for approximately one
minute, after which the hob goes
automatically on to standby.
Residual heat warning
When the hob has been operating for some
time, there will be some residual heat. The
letter "H" appears to warn you to keep
away from it.
Auto shutdown
Another safety feature of the induction hob
is auto shutdown. This occurs whenever
you forget to switch off a cooking zone.
The default shutdown times are shown in
the table below:
The heating zone shut down
Power level
1~3
4~6
7~9
When the pan is removed from the cooking
zone, it stops heating immediately and
switches itself off after the buzzer has
sounded for one minute.
Warning: Anyone who has been fitted with a
heart pacemaker should consult a doctor
before using the induction hotplate.
automatically after
8 hours
4 hours
2 hours
Installation
1. Cut a hole in the worktop of the dimension
shown in the diagram below. A minimum of
50 mm space should be left around the
hole. The worktop should be at least 30
mm thick and made of heat-resistant
material.
As shown in Figure (1)
+0.4
56
cm
+0.1
Flush installation: Feasible only if the oven is not
installed under the counter
2. It is essential that the induction hob is well
ventilated and that the air intake and exit
are not blocked.
Make sure the hob is correctly installed as
shown in Figure 2.
Figure (2)
mini 5 cm
mini 2 cm
Air intake
EN-5
SEAL
+0.4
49
cm
+0.1
Figure (1)
mini 760mm
Air exit
mini 5 mm
Figure (2)

Publicité

loading