Publicité
Les langues disponibles
Les langues disponibles
Cleanness and Maintenance
The surface of the induction hob may be easily cleaned in the following way:
Type of
contamination
Light
Immerse in hot water and wipe dry
Rings and lime
Apply white vinegar to the area, wipe with
scale
a soft cloth or use a commercially available
product
Sweetmeat, melted
Use a special scraper for ceramic glass to
aluminium or
remove residue (a silicon product is best)
plastics
NB: Disconnect the power supply before cleaning.
Failure Display and Inspection
If any abnormality occurs, the induction hob will automatically go into protective mode and display
one of the following codes:
Failure code
E1
Supply voltage is above the rated voltage.
E2
Supply voltage is below the rated voltage.
E3
High temperature of ceramic plate sensor. (1#)
E4
High temperature of ceramic plate sensor. (2#)
E5
High temperature of IGBT. (1#)
E6
High temperature of IGBT. (2#)
Ceramic plate temperature sensor failure- -short
F3/F6
circuit. (F3 for 1#,F6 for2#)
Ceramic plate temperature sensor failure--open
F4/F7
circuit. (F4 for 1#,F7 for2#)
Ceramic plate temperature sensor failure--invalid. (F5
F5/F8
for 1#,F8 for2#)
Temperature sensor of the IGBT failure, (short
F9/FA
circuit/open circuit for 1#)
Temperature sensor of the IGBT failure, (short
FC/FD
circuit/open circuit for 2#)
Method of cleaning
Problem
Auto-Recovery
No Auto-Recovery
EN-16
Cleaning materials
Cleaning sponge
Special adhesive for ceramic
glass
Special adhesive for ceramic
glass
Solution
Please inspect whether power supply is normal.
Power on after the power supply is normal.
Wait for the temperature of ceramic plate return to
normal.
Touch "ON/OFF" button to restart unit.
Wait for the temperature of IGBT return to normal.
Touch "ON/OFF" button to restart unit.
Check whether the fan runs smoothly;
if not, replace the fan.
Check the connection or replace the ceramic plate
temperature sensor.
Replace the power board.
Publicité
