Bartscher GE 21 Mode D'emploi page 32

•
Before pouring liquids into the device, ensure that the spout is closed.
•
Pour a drinkable liquid into the tank of the mulled wine pot / boiling water canner.
Observe the „MIN" and „MAX" markings inside the device!
WARNING! Danger of electric shock!
Do not allow liquids to splash when the device is in use to avoid
damage to electronics systems. Users may be electrocuted as a result.
•
Turn the temperature dial to the „OFF" position.
•
Connect the device to a single grounded outlet.
•
Always place the lid on the tank before turning it on, and leave it there while the
device is heating.
WARNING! Danger of burns!
When opening the lid there is a danger of burns from steam and condensation.
Carefully lift the lid so that condensation flows into the tank.
•
The temperature dial can be used to set the
temperature within a range of 30 ° C - 90 ° C – MAX .
Set the desired temperature by turning the
temperature dial clockwise. The red heating
control light will come on. After the desired
temperature between 30 ° C - 90 ° C is reached
the device's thermostat will be turned off
automatically by the thermostat.
If the liquid's temperature falls the thermostat will
again resume heating, maintaining the liquid at
the desired temperature for long periods of time.
•
If the desired temperature is 100 ° C , turn the temperature dial clockwise to the
„MAX" position. The water will remain at boiling, and the thermostat will not turn
the device off automatically.
NOTE!
Heating time depends on the amount and type of liquid.
Temperature dial
Heating control light
- 31 -