cecotec Mambo 10070 Manuel D'instructions page 53

E2 Temperature
COLOCAR sensor error
JARRA
PUT JUG
E3 The motor is
CONTENIDO blocked.
SUPERADO
FULL
CONTENT
E4 The temperature is
ALTA TEMP too high.
HIGH TEMP
E5 The motor's
MOTOR temperature is too
TEMP high.
E6 The change in
speed could not be
done successfully.
E7
FALLO
ENGRANAJE
GEAR FAULT
and E8
FALLO NTC
NTC FAULT
E12
PESO Scale
SUPERADO measurement
error.
OVER
WEIGHT
E14
Linking process
FALLO WIFI
error.
WIFI FAULT
The jar is not in its correct
position or connection
of the temperature
sensor at the jar base is
damaged.
There is too much food
inside the jar.
There is no or very little
food in the jar and the set
temperature is too high
for too much time.
The robot has been
operating with too much
food for a long time.
Speed change between
low level (1-5) and high
level (6-10) was blocked.
The maximum measuring
value has
been exceeded.
An error occurred at some
point of the linking process.
ENGLISH
Re-assemble the jar and make
sure it is fixed properly.
Remove some food from
inside the jar or cut the food to
smaller pieces and restart the
machine.
Add food in the jar.
Stop operating the machine
and allow it to cool down
before restarting it again.
Remove the jar, turn the fixing
bracket manually and place
the jar again in place. Restart
the robot.
Please, contact the Technical
Support Service of Cecotec at
+96 321 07 28.
Remove weight from the
scale until it reaches a value
below 4.999 g.
Switch it off. Start the linking
process again. If the problem
continues, contact the
Technical Support Service of
Cecotec +34 96 321 07 28.
53