Activating/Deactivating The Signal Tone (Beep On/Off); Setting The Speed-Dependent Volume Increase (Auto Sound) - Blaupunkt Hamburg MP57 Mode D'emploi

User settings
case, the volume listened to is used
for mute.
•
if the volume currently listened to is
higher than the set TEL volume. In
this case, phone calls/navigation an-
nouncements are reproduced with
the volume listened to.
Activating/deactivating the signal tone
(BEEP ON/OFF)
You can deactivate the signal tone that
sounds as a confi rmation in the menus or
when storing the stations on the station but-
tons.
In the Volume menu, press the rocker
u
=
switch or
"BEEP ON/OFF" is displayed.
Switch between the settings with the
u
rocker switch or
•
"BEEP OFF" signal tone off
•
"BEEP ON " signal tone on
Setting the speed-dependent volume
increase (AUTO SOUND )
When you are driving faster, the device can
automatically increase the volume to com-
pensate for the driving noise. The volume is
increased depending upon the speed. In or-
der for this to work, the speedometer signal
must be connected as described in the in-
stallation instructions.
The optimum setting for this volume in-
crease depends on how noise levels devel-
op in your particular vehicle. Try the setting
that is perfect for your vehicle. You can se-
lect a value between 0 (no increase) and
max. 5.
48
repeatedly until
:
.
In the Volume menu, press the rocker
u
=
switch or
"AUTO SOUND" is displayed.
Press the rocker switch
u
the setting.
Set the desired value with the rocker
u
=
switch or
repeatedly until
:
to display
.