Bodet Cristalys Instructions De Mise En Service Et D'utilisation page 24

I - INITIAL VERIFICATION
Thank you for choosing a BODET clock. This product has been carefully designed for your
satisfaction based on ISO9001 quality requirements. We advise you to read this manual
thoroughly before attempting to manipulate the clock.
These indicate important comments.
Keep this booklet during all the life of your clock, so that you can refer to it each time it is
necessary.
1.1 Unpacking the clock
Unpack with caution and check the contents of the packaging. It must contain :
The Opalys or Cristalys Ellipse clock clipped on to its wall holder,
A fixation kit (2 screws + 2 rawlplugs),
A cleaning kit (impregnated antistatic cloth),
This booklet,
with option, a table holder.
Remark : when unpacking, some segments of the clock can be activated. This is not a
default, connect the low voltage power supply and after a few seconds the problem will
disappear.
Versions : A descriptive label is fixed to the back of the clock :
NTP PoE = the clock is configured as a receiver (controlled by a master clock sending
SNTP coded time messages, for example: Sigma Mod); it is powered by the network
(Power over Ethernet).
Bodet accepts no responsibility for any use not in compliance with these instructions.
Any modification on the product will invalidate the warrantee
1.2 Backup
All the parameters for the clock are saved permanently even in the absence of power.
24
All manuals and user guides at all-guides.com