STORZ & BICKEL Volcano Classic Mode D'emploi page 65

Take care that the Screens are
not obstructed with plant ma-
terial. To guarantee optimal re-
sults, we recommend cleaning the
Screens after each vaporization cycle
with the enclosed Cleaning Brush.
Put the Filling Chamber with Cap on the
hot air outlet of the Hot Air Generator
and allow it to lock in place. Switch on
the air pump. To do so, press the green
button/switch labeled "AIR". The Filling
Chamber as well as the vaporization
material must be preheated for a cou-
ple of seconds before the aromas and
fragrances start to vaporize. Before at-
taching, remove the Mouthpiece from
the Valve Balloon.
approx. 5 sec
Preheat plant material for a few seconds
8. E A S Y VA LV E
loon is placed vertically on the Hot Air
Generator when it is filled.
Valve Balloon
Put the Valve Balloon on the Filling
Chamber and allow it to lock in place.
This will open the Valve. Now the Valve
Balloon will fill with vapor.
Only fill the Valve Balloon with the ap-
proximate amount of vapor that you in-
tend to use within the next 10 minutes.
Do not fill the Valve Balloon completely
(overpressure) in order to prevent the
loss of vapor. It is important to observe
65
Before putting the Valve Bal-
loon on the Filling Chamber,
stretch it tight so that the Bal-
Stretch
tight