STORZ & BICKEL Volcano Classic Mode D'emploi page 62

6. G E N E R A L I N F O R M AT I O N A B O U T
6.7. Troubleshooting
If the device does not function properly when the power plug is connected to the
power socket, please check the Hot Air Generator using the tips in the following
table:
Problem
No aerosol is formed.
The Valve Balloon does
not fill up.
Plant particles in the
Valve Balloon (when
using plant material).
If the preceding tips do not
yield the desired results, or for
any other defects or prob-
lems not mentioned here, please un-
plug the power plug and contact our
Service Center immediately.
Do not open the Hot Air Gen-
erator! Without special tools
and specialized knowledge,
any attempt to open the device will
cause damage to it. Such an attempt
will invalidate the warranty claim.
T H E V O L C A N O C L A S S I C
Possible Cause/Remedy
Check the set and actual temperature.
Make sure the Filling Chamber and/or Valve Balloon
were correctly attached.
Check whether there is fresh, unused plant material in
the Filling Chamber.
Check whether the pump is turned on.
Check whether the Filling Chamber and/or Valve
Balloon are correctly attached.
Check whether the Screen in the Filling Chamber Cap
is clogged or is not inserted into the notch properly.
Check whether the Filling Chamber was cleaned
according to the Instructions for Use.
Do not try to remedy the defect your-
self. Contact our Service Center direct-
ly.
62