Télécharger Imprimer la page

VOLTCRAFT VC 260 Mode D'emploi page 35

Publicité

Les langues disponibles

Les langues disponibles

c) "RESET" button (3)
By means of this button you can set the display of the "Reference
value measurement" to "00.00". This is very useful, for the resi-
stance measurement in the low-resistance range in particular,
because the inherent resistance of the measurement cables can be
compensated.
This function is activated by pressing the "RESET" button. Then, the
Delta symbol is displayed top right to the measured value. This
value is the difference between the current measuring value and the
reference value. You can leave this function by pressing the
"RESET" or "SELECT" button anew or by changing the position of
the SELECT button or of the rotary switch.
Note!
The reference value measurement can only be activated for the
resistance measurement if OL for overload is not displayed. The
same principle applies for the continuity check.
B Rotary switch (2)
You find the following measuring functions arranged in a semicircle:
V~/-
Hz
µA~/-
mA~/-
A~/-
CHARGE 230V MAX
CHARGE 9-12V~/-
All manuals and user guides at all-guides.com
Direct and alternating voltage
measurement
Resistance measurement, diode test,
continuity check, frequency-
measurement
Frequency measurement
Direct and alternating voltage measure-
ment in microampere
Direct and alternating voltage
measurementin milliampere
Direct and alternating voltage measure-
ment in ampere
Charging with 230V alternating current
Charging with min. 9 to max. 12V direct
or alternating current
35

Publicité

loading