Barbecook Brahma 4.2 Inox Mode D'emploi page 38

solVinG problems
Probleem
Impossible to light burner (with igniter
or match)
Not enough heat
Yellow flames
Flames jumping out of the burner box
Excessive heat and flare-ups
Flames behind control panel
Regulator humming
Incomplete flame
TroUblesHooTinG GUiDe For elecTric iGniTion
Problem
No sparks when pressing the ignition;
no sound
No sparks when pressing the ignition;
sound is present
Sparks are present but not with all elec-
trodes and/or not powerful enough
AROMAZ SYSTEM
®
Under the grid of the Brahma are two saucers that you can fill with your favourite barbecue seasoning (wine, beer, port, herbs
or smoke chips with water, etc.).
The Aromaz system makes for the juiciest and most flavourful dishes ever prepared on a gas barbecue.
®
38 www.barbecook.com
MAN_BRAHMA-4,2-5,2_DE_BBC130606_A.indd 38
All manuals and user guides at all-guides.com
Probable cause
• B locked venturi tubes
• G as cylinder valve is not open
• V enturi tubes not positioned over exhaust valves
• B locked burner openings
• C ylinder is empty or almost empty
• R egulator not fitted correctly on cylinder
• V enturi tubes are partly blocked
• S alt on burner
• T he product is connected to Buthane.
• W indy weather
• C ylinder almost empty
• T he bottom of the burner bowl is dirty.
• T oo fatty food
• B locked fat drain hole
• C ooking system not positioned correclty
• B locked venturi tubes
• T emporary situation caused by high outside temperature or
full cylinder
• B locked, pierced or rusted burner
Probable cause
• B attery not installed correctly
• F lat or missing battery
• I gnition button not installed correctly
• D efective spark generator
• F aulty ground
• B urner and electrode are positioned too far apart
• F aulty ground
• S park flashover away from burner(s)
• L ow battery
• E lectrodes are wet
• E lectrodes cracked or brokenn "sparks are present"
Solution
• C lean venturi tubes
• O pen gas cylinder valve
• R einstall venturi tubes
• C lean openings or fit new burner
• N ew cylinder
• T ighten up connector of regulator
• D isconnect hose
• C lean venturi tubes
• C lean burner
• C onnect the product to Propane with the right connector.
• M ove barbecue with rear side pointing towards the wind
• N ew cylinder or fill up
• C lean the fire bowl of the barbecue.
• T rim excess fat or reduce heat
• C lean bottom of burner box and burner
• P osition cooking system correctly
• S hut off gas immediately, allow barbecue to cool down and
clean venturi tubes
• T his is not a defect or a hazard
• C lean / replace burner
Solution
• I nstall battery (ensure that "+" and "-" are oriented cor-
rectly, with "+" at the top and "-" at the bottom)
• R eplace with new AA battery
• S crew off button and reinstall
• R eplace spark generator
• R emove and reconnect all connections with spark generator
and electrodes
• B ring the electrode closer to the burner by bending it slightly
• R emove and reconnect all connections to the spark genera-
tor and the electrodes
• I f sparks are present that do not originate from the
burner(s), the wiring may be damaged. Replace the wiring.
• R eplace with new AA battery
• U se paper tissues to remove the dirt
• R eplace cracked or defective electrodes
10/06/13 11:18