Dometic Oceanair Skyscreen Powered Instructions De Montage Et De Service page 18

Masquer les pouces Voir aussi pour Oceanair Skyscreen Powered:

Installation

7.2

Frame fitting

NOTICE! Damage hazard

• Use packing material where required (fig. 9, page 7).

• Use suitable screws and plugs for the wall construction to fix the frame to

the recess. Pre-drill at the marked points.The heads of screws may be no

larger than 6.0 mm in diameter.

• Ensure not to drill through the wall.

• Ensure not to damage the channel in the side tracks.

• Take care not to leave screws or other debris inside the side tracks as this

can jam the shoes in the tracks.

Proceed as shown:

1. Align the blind with the window cut-out and mark where the holes are to be

drilled for the frame.

2. Ensure the frame is square within the recess by using a measuring device.

Measure the outside corner of the frame to the opposite outside corner and

repeat for the other two corners. These measurement should be within

3 mm of each other (fig. 9, page 7).

3. Fix the frame with the screws to the ceiling (fig. 0, page 7).

If packing of tracks is required do not fully tighten the screws before packers

are in place as this can cause damage to the tracks.

It might be easier to loosely fit the four corner screws (1.) first to position and

hold the blind while the main fixings (2.) are fitted.

7.3

Fitting the moving rails and fabric cassette panels

Before fitting the fabric panel observe the following:

• Check whether the moving rail is square and moves freely before fitting any

of the other panels. If the moving rail is not square it can be adjusted as shown

(fig. 8, page 6).

• Ensure that the gliders are inserted into moving rail correctly and are free to

move (fig. a, page 8).

For fitting the blind panels proceed as follows:

1. Fit the moving rail (fig. a, page 8, 1 and 2). Dependent on the version the

blind is equipped with one or two moving rails.

• Connect the power (see chapter "Electrical installation" on page 19) and

drive the moving rail away from the head rail before fitting the panels. There

is not enough space to fit the panels with the shoes in the shipped position.

2. Clip the fabric cassette panel to the shoes (fig. a, page 8, 3 and 4).

Skyscreen Powered