Bosch GCM12SD Consignes D'utilisation/De Sécurité page 42

2610051827 GCM12SD 08-18.qxp_GCM12SD 9/19/18 2:52 PM Page 42
Pitch angle information – The top section of the miter scale shows angle settings required to
cut roof rafters to the "Pitch Angle" system. 2/2, 4/12, 6/12, etc., are all pitch angles. This system
is based on using the English "inches." A 6/12 pitch angle roof equals a ratio of 6" "rise" for every
12" "run" (see Figure 45).
Fig. 45
Crown molding information – There are miter position settings for compound-cutting crown mold-
ing flat on the table. Crown molding with 38° "spring angle" uses the 31.6 setting (with detent)
and crown molding with 45° "spring angle" uses the 35.3 setting. NOTE: This cutting method also
requires that specific bevel angles are set – see Cutting Crown Molding on page 50.
42
.800.544.2843
Saw Operations
Miter Cuts
12
RISE
12 RUN
12/12
www.calcert.com
15
10 20
5 25
30
0
6
RISE
12
RUN
6/12
sales@calcert.com