Bosch GCM12SD Consignes D'utilisation/De Sécurité page 32

2610051827 GCM12SD 08-18.qxp_GCM12SD 9/19/18 2:52 PM Page 32
cutting easier and safer. Failure to follow all in-
structions, identified below by bullet (•) sym-
bols, may result in serious personal injury (see
Fig. 31 below).
CORRECT
Fig. 31
• Never place hands near cutting area. Keep
hands and arms outside the "NO HANDS"
zone.
The "No Hands Zone" is an area 6 inches wide on
left and right side of the blade cutting path. Por-
tion of the Fence in this are also is considered a
part of the "No Hands Zone".
The "No Hands Zone" for zero miter and zero
bevel cuts is marked on the tool with lines and
"No Hands" symbols.
32
.800.544.2843
Preparing for Saw Operations
Body and Hand Position
Position your body and
hands properly to make
INCORRECT USE
6" 6"
www.calcert.com
15
10 20
5 25
30
0
The "No Hands Zone" for all slide and miter right
cuts is defined in figure below.
The "No Hands Zone" for all slide and miter left
cuts is defined in figure below.
6"
6"
With all bevel cuts the "No Hands Zone" extends
vertically up to the bottom of the upper guard
when the head assembly is in the lowest cut po-
sition.
6"
6"
sales@calcert.com