Roland Edirol AUDIOCapture UA-1D Mode D'emploi page 11

Making connections and installing the driver
Windows Me Users
* If you are using a Windows 2000 machine, refer to p. 12, if
Windows 98, refer to p. 12.
1
Turn on the power of your computer and start up
Windows, and use a USB cable to connect the UA-1D
to your computer.
fig.02-03.e
2
When Windows detects
the UA-1D and the Add
New Hardware Wizard
dialog box appears, make
sure "Automatic search
for a better driver
(Recommended)" is
selected, then click [Next].
3
The search for the driver starts.
4
When the correct driver is found, driver installation
starts.
fig.02-04.e
5
When a dialog box
informing you that driver
installation has finished
appears, click [Finish], and
restart Windows.
After installing the driver, refer to
Specifying the audio input/
output device (p. 15) and select the device Windows uses.
After that, refer to Installing and Using the D-Out Smoother
(p. 19) to install the D-Out Smoother on your computer.
* Depending on your computing setup, there may be a short wait after
the driver is installed until the device is recognized.
Connections and driver installation (Windows)
To prevent damage to your
speakers, turn down the
volume on any audio
devices you may have
connected.
Some time may be required
until this dialog box appears.
11