Publicité
Les langues disponibles
Les langues disponibles
BAKEWARE/
RECOMMENDATIONS
RESULTS
Insulated cookie
Place in the bottom third of oven.
sheets or baking
May need to increase baking time.
pans
Little or no
bottom
browning
Stainless steel
May need to increase baking time.
Light, golden
crusts
Uneven
browning
Stoneware
Follow manufacturer's instructions.
Crisp crusts
Ovenproof
May need to reduce baking
glassware,
temperatures 25°F (15°C).
ceramic glass or
ceramic
Brown, crisp
crusts
Oven Vent
A. Oven vent
The oven vent releases hot air and moisture from the oven, and
should not be blocked or covered. Blocking or covering the oven
vent will cause poor air circulation, affecting cooking and
cleaning results. Never set plastics, paper or other items that
could melt or burn near the oven vent.
Baking and Roasting
IMPORTANT: Never light the oven burner during a power failure.
Never place food or cookware directly on the oven door or the
oven bottom. When using the oven for the first time, it is
necessary to turn any one of the surface burners on first to
release air from the gas lines.
Before baking and roasting, position racks according to the
"Positioning Racks and Bakeware" section.
To Bake or Roast:
1. Touch BAKE.
Touch TEMP "up" or "down" arrow pads to set a temperature
other than 350°F (177°C) in 5°F (3°C) amounts. The bake
range can be set between 170°F and 500°F (77°C and
260°C).
10
A
2. Touch START/ENTER.
The temperature can be changed at any time after this step
by touching the TEMP "up" or "down" arrow pads. START/
ENTER does not need to be touched again. If baking/roasting
while the Timer is counting down, the set baking/roasting
temperature can be displayed for 5 seconds by touching
BAKE.
3. Touch OFF/CANCEL when finished.
Preheating
After START/ENTER is touched, the oven will enter a timed
preheat conditioning cycle. The Temp, Bake, and On indicator
lights will light up. The Electronic Oven Control automatically
selects the conditioning cycle time based on the oven
temperature selected. The conditioning cycle time will not
change if the temperature is reset before the cycle countdown
ends. The preheat conditioning cycle is complete and the oven is
ready to use when a 1-second tone sounds, the cycle countdown
ends, and the set temperature is displayed.
Preheat temperatures are affected by varying factors such as
room temperature and peak energy usage times. It is normal for
the temperature showing on the display and the actual oven
temperature to differ.
Waiting an additional 10 minutes after the preheat conditioning
time ends to put food in the oven is suggested when baking
foods with leavening ingredients, such as yeast, baking powder,
baking soda and eggs.
Broiling and Custom Broiling
BROILER
The broiler is located below the oven door. The broiler pan and
grid roll out for easy access. Always broil with the broiler and
oven doors closed.
Do not step on or apply weight to the broiler door while it is
open.
Do not preheat broiler before use. Completely close broiler
door during broiling.
Do not use broiler drawer for storage.
Use only the broiler pan and grid provided with the appliance.
It is designed to drain juices and help prevent spatter and
smoke.
For proper draining, do not cover the grid with foil. The
bottom of the pan may be lined with aluminum foil for easier
cleaning.
Trim excess fat to reduce spattering. Slit the remaining fat on
the edges to prevent curling.
Pull out oven rack to stop position before turning or removing
food. Use tongs to turn food to avoid the loss of juices. Very
thin cuts of fish, poultry or meat may not need to be turned.
After broiling, remove the pan from the oven when removing
the food. Drippings will bake on the pan if left in the heated
oven, making cleaning more difficult.
Publicité
