Publicité
Les langues disponibles
Les langues disponibles
Circular damper
Table of content
1. Installation video
2. General information
3. Control configuration
4. Kit and recommended tools
5. Damper installation
6. Damper cable installation
7. Fixation tools
8. Control board
2. General information
The equipment of the option will be delivered separately
from the unit and must be installed by the installer.
Electrical cables must be adjusted to the unit. Connect
length to avoid any damage inside the unit
The damper will be used to isolate any passage of outside air
into the unit when the unit is stopped.
3. Control configuration
In addition to installing and connecting the option, configure
the unit's option in the control using the commissioning
manual.
2
MULTI.CTc.230725
4. Kit and recommended tools
Kit delivered with each coil, separatly from the unit.
Tools not provided.
Components kit
1. Cable
2. Damper
gland
Picture 1
Recommended tools
3. Precision
4. Wire
5. Cutter
screwdriver
stripping pliers
Picture 2
The document was originally written in English.
We reserve the right to alter specifications.
5. Damper installation
+
•
Adaptor : not provided.
•
Place the circular adaptor on the connexion carrying outside air.
•
To ensure a airtightness, check the position of the adaptor.
•
For more stability: the adaptor can be fixed to the unit connection using self-drilling screws
(not supplied - minimum of 3 fixing points around the adaptor).
•
The cable can be fixed to the unit with fasteners brackets (not supplied - minimum 1 bracket)
•
It is important to leave the doors accessible.
For some models:
To add a new cable gland :
•
To install the cable gland : open the pre-drilled circles
with a cutter and install the gland provided in the kit.
We reserve the right to alter specifications.
MULTI.CTc.230725
=
3
Publicité
