Indicator Lights; Before Firs Use; Daily Use; Setting The Time Of Day - Zanussi ZOB9990X Notice D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

3172746-000 In-Fr ZANUSSI 03/07/14 11:20 Página 7
Cooking duration
End of cooking
Minute minder
Time of day
Before first use
There may be traces of grease and other substances in
the oven as a result of its manufacturing process. These
should be removed by means of the following
procedure:
• Remove all of the packaging from your oven,
including the protective plastic, if any.
• Turn the oven to setting
defect settingt

Daily use

In the event of a power failure, all the settings
(time of day, programme setting or programme in
operation) will be cancelled. When the power is
restored, the numbers in the display will flash,
and the clock/timer has to be reset.

Setting the time of day

When the power supply is switched on, or after a power
failure, the "Time of day" pilot lamp will flash on the
display.
www.zanussi.com

Indicator lights

Illuminates when a programmed cooking duration is set and will start
flashing when the cooking time is over.
Illuminates when a programmed end of cooking is set and will start
flashing when the cooking time is over.
Illuminates when the minute minder alarm is set.
Flashes when setting the time of day is carried out.
, or else place it on the
, at 200ºC, for 1 hour. Consult
the Quick Start Guide accompanying this manual on
how to do this.
• Cool the oven with the door open so that it
ventilates and no odours remain inside it.
• Once cold, clean the oven and accessories.
During this first operation, smoke and smells will be
produced. The kitchen should therefore be well
ventilated.
To set the correct time of day:
1. Press button
or
2. After the setting is carried out, wait for 5 seconds:
the "Time of day" pilot lamp
the display will show the set time. The appliance is
ready for use.
To reset the correct time of day:
1. Press button
repeatedly to select the "Time of
day" function. The relevant pilot lamp will start
flashing. Then proceed as described above.
The time of day can only be reset if no automatic
function (cook duration
has been set.
.
will go out and
or end of cooking
)
7

Publicité

Chapitres

Table des Matières
loading

Table des Matières