Zanussi ZOB9990X Notice D'utilisation page 10

3172746-000 In-Fr ZANUSSI 03/07/14 11:20 Página 10
End of cooking
Cooking duration and
End of cooking time
combined
Minute minder
10
Electronic programmer functions
NOTE: turning the acoustic alarm off will reset the oven to manual, and if the
oven function and the thermostat knobs are not set to zero the oven will start
to heat again.
To cancel the End of cooking time:
1. Press button repeatedly to select the "End of cooking" function. The
relevant pilot lamp will flash and the display will show the programmed
End of cooking time.
2. Press button until the display shows the current time of day. The
programmer will beep and the pilot lamp will go out.
The functions "Cooking duration" and "End of cooking time" can be used
simultaneously to set the oven to switch on and off automatically at a later
time.
1. With the "Cooking duration" function (carry out the cooking duration
setting as described in the relevant chapter) set the duration time. Then,
press button : the display will show the programmed setting.
2. With the "End of cooking time" function (carry out the End of cooking setting
as described in the relevant chapter) set the end of cooking time.The relevant
pilot lamps will come on and the display will show the time of day. The oven
will switch on and off according to the set programmes.
Electronic programmer functions
The minute minder alarm will sound at the end of a timed period, but THE
OVEN WILL REMAIN ON, if it is in use.
To set the minute minder:
1. Press button repeatedly to select the "Minute minder" function. The
relevant pilot lamp will start flashing.
or
2. Then, press button
3. After the setting is carried out, wait for 5 seconds: the "Minute minder"
pilot lamp will come on.
4. At the end of the timed period, the pilot lamp will start flashing and an
acoustic alarm will be heard. To switch off the acoustic alarm, press any
button.
To cancel the minute minder:
1. Press button repeatedly to select the "Minute minder" function. The
relevant pilot lamp will flash and the display will show the remaining time.
2. Press button until the display shows "0:00". After 5 seconds the pilot
lamp will go out and the display will revert to the time of day.
(maximum: 2 hours, 30 minutes).
www.zanussi.com