Publicité
INSTALLATION PROCEDURE
EQUIPMENT LIST
Integrating an air inlet control system into your ventilation system
requires the following equipment:
a Comlink-2 communication module added to your controller
a PF-6 controller for each air inlet panel (up to 100 in all)
an alarm system (optional)
a DC power supply (optional)
a power unit equiped with a 10 turn potentiometer (> 1 kOhm)
1. MOUNT THE PF-6
Remove the four screws in the front cover and lift the cover. Remove
the black caps located on the three mounting holes. Mount the enclosure
to the wall using three screws. Be sure the electrical knockouts are at
the bottom of the enclosure in order to prevent water from entering the
controller. Insert the screws into the mounting holes and tighten. Fasten
the black caps onto the mounting holes.
2. MAKE THE CONNECTIONS
To connect the equipment, refer to one of the two wiring diagrams
enclosed with this user's manual depending on whether you are using an
AC or DC type power unit motor. Also refer to the DC power supply
wiring diagram when using a DC type motor.
7
PF-6.rev.14
Publicité
