Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY OF ENGINE AND SHAFT
CAUTION: Before doing any work on the petrol brush cutter, always switch off
the motor and pull the spark plug connector off the spark plug.
Always wear protective gloves!
CAUTION: Start the Petrol Brush Cutter only after having assembled it
completely.
– After checking the parts, fasten the drive shaft to the engine with four bolts M6
x 30 (1).
– Mount the stand by two screws M5 x 12 (2).
MOUNTING OF HANDLE For BH3600
MOUNTING OF HANDLE
– Place the handle with the throttle lever on the handle holder on the right side
(to be held by the right hand) and the other on the left side.
– Fit the handle edge to the handle holder groove, and provisionally fix the
upper side (3) of the handle holder by four bolts M5 x 25 (4).
– Adjust the handle to an angle easy to manipulate, and tighten the bolt (4)
uniformly on the right and left sides.
– Fix the control cable to the shaft by two clips (5).
All manuals and user guides at all-guides.com
9
(1)
(2)
(4)
(3)
Clips (5)
Publicité
