Télécharger Imprimer la page

Tecno-gaz PURA Plus Mode D'emploi page 36

Déminéralisateur

Publicité

Les langues disponibles
  • FR

Les langues disponibles

ENGLISH
PACKAGING – TRASPORT - STORAGE
The device is wrapped in a nylon sheet and placed in a corrugated cardboard box.
Stability is guaranteed by cardboard fillers and by the accessories in the box.
Transport must be done according to the regulations regarding fragile goods.
There are no particular problems with storing the product; it is possible to stack up to five
boxes containing the same product and shelf life is unlimited if kept at a temperature of
between 0 and 50°C.
The original packaging material must be kept during the whole guarantee period, since
only with such material it is possible to transport the product without damaging it.
Failure to comply with the above shall result in termination of the guarantee.
INSTALLATION
IMPORTANT:
A. DO NOT INSTALL UNDER OTHER TAPS THAT COULD WET THE WATER CLEAN.
B. DO NOT INSTALL NEAR SOURCES OF HEAT.
C. DO NOT INSTALL THE DEVICE OUTSIDE, FROST WOULD DESTROY THE DEVICE.
D. THE DEVICE INSTRUMENT SHOULD BE POSITIONED WITH ITS OUTLET FITTING AT A
HIGHER LEVEL THAN THE INLET FITTING OF THE AUTOCLAVE. IF THIS IS NOT DONE, THE
TAP LOCATED ON THE OUTLET FITTING WILL HAVE TO BE CLOSED DURING
MAINTENANCE WORK AND WHEN CHANGING THE FILTERING CARTRIDGES, SO THAT
WATER CANNOT ESCAPE.
E. INSTALL A TAP WITH A ¾" MALE FITTING (STANDARD CONNECTION FOR WASHING
MACHINES AND DISHWASHERS) ON THE MAINS WATER PIPE TO SUPPLY THE DEVICE.
ALTERNATIVELY YOU CAN USE THE ½" SUPPLIED CONNECTION (COD. 2ZPUA0002; SEE
CHAPTER ACCESSORIES), WITH ON TAP.
F. INSTALL A WATER DRAIN LINE FOR THE WASTE WATER PRODUCED BY THE DEVICE. IF
NECESSARY, USE THE COLLAR SUPPLIED WITH THE INSTRUMENT, (Code SPUA035) THAT
SHOULD BE INSTALLED ON THE SINK TRAP.
NOTE 1: The device can be installed by placing it on the filters or attaching it to the wall with
the filters facing downwards and fixing it with the designated holes made in the bracket itself.
NOTE 2: Make sure the low level led of the clean water tank of the autoclave is on; if it is not,
discharge the water from the tap on the rear panel of the autoclave (see manual for use of
the autoclave).
10

Publicité

loading

Ce manuel est également adapté pour:

Oi002npu