Zipper Maschinen ZI-EWB500 Mode D'emploi page 28

Clean your machine regularly after every usage – it prolongs the machines lifespan and is
a pre-requisite for a safe working environment.
Repair jobs shall be performed by respectively trained professionals only!
Check regularly the condition of the security stickers. Replace them if required.
•
Check regularly the condition of the machine.
•
• Store the machine in a closed, dry location.
14.2.1 Maintenance plan
After each workshift:
Check the cables (tight fit, damage)
•
Monthly
•
Charge the battery: if the machine is stored for a longer period of time.
14.3 Storage
Clean thoroughly all components before storage.
Store all components separately in a dry area at not less than -10 ° C.
Important notes on storing the battery to avoid possible damage:
If the machine will not be used for a longer period of time, the battery should be disconnected and disas-
sembled from the machine. Before storage, the battery should be charged again. An exception to this rule
are batteries permanently installed in the machine, which should not be disassembled and simply charged
with the charger supplied. Batteries should be stored at room temperature (approx. 20° C) in a dry and frost-
proof place. Avoid large temperature fluctuations (e.g. do not expose battery to direct sunlight or store near
heating systems). Higher temperatures can lead to accelerated ageing and premature loss of function of
the battery. If the battery is not used for a longer period of time, check the charge level regularly (monthly,
max. every 3 months). If necessary, recharge the battery.
14.4 Disposal
Observe the national waste disposal regulations. Never dispose of the machine, machine com-
ponents or operating equipment in the residual waste. If necessary, contact your local author-
ities for information regarding available disposal options.
If you purchase a new machine or equivalent equipment from your specialist dealer, he is
obliged in certain countries to dispose of your old machine properly.
15 TROUBLESHOOTING
BEFORE YOU START WORKING FOR THE ELIMINATION OF DEFECTS, UNPLUG THE BATTERY.
Trouble
No electrical support
No charging of battery
ZIPPER MASCHINEN GmbH www.zipper-maschinen.at
ZI-EWB500-AKKU
Possible cause
Battery is not charged
Motor stucks
Power switch is damaged
Broken or loose cables
Loosen cable
TROUBLESHOOTING
Solution
Recharge battery
Check motor
Check switch
Check cables
Check cable connection
28