SRAM Avid Elixir 9 Mode D'emploi page 5

Elixir/Code User Manual
adJUst HosE anglE, tHEn RoUtE
3
(ElixiR 9/ElixiR 7)
If necessary, you can change the banjo position to improve
hose routing. Lightly loosen the banjo bolts on the caliper
with an 8 mm open end wrench and rotate the fittings for
optimal routing. Re-tighten the banjo bolts to the specified
torque, then route the hose. Make sure there is enough
hose to allow for suspension movement, but not any big
loops of extra hose. Now, secure the hose to the frame
or fork.
you may have introduced air into the system by
changing the banjo position. you must take the time
to bleed the system when you are done with the
installation.
adJUst HosE anglE, tHEn RoUtE
(CodE/CodE R)
If necessary, you can change the banjo position to improve
hose routing. Start by removing the brake pads so you
don't risk getting DOT fluid on the pad surface (see pad
replacement steps for directions). Next, use a 5 mm hex
wrench to slightly loosen the front caliper body bolt. Rotate
the banjo fitting to the desired position and re-tighten the
caliper bolt to the specified torque. Make sure there is
enough hose at to allow for suspension movement, but not
any big loops of extra hose.
you may have introduced air into the system by
changing the banjo position. you must take the time
to bleed the system when you are done with the
installation.
Copyright ©2011 SRAM, LLC
All manuals and user guides at all-guides.com
English
8.5-10.1 N•m
(75-90 in-lb)
8.5-10.1 N•m
(75-90 in-lb)
5