SRAM Avid Elixir 9 Mode D'emploi page 4

English
install RotoR
1
Mount the rotor to the hub using the supplied T25 TORX® bolts and
tighten to 6.2 N•m (55 in-lb). Avid logo MUST face out. Install the wheel
into the fork or frame.
MoUnt FRont and REaR CaliPER
2
Mount the front caliper (shorter hose) to the fork and the rear caliper (longer hose) to the frame.
9-10 N•m (80-90 in-lb)
i.s. MoUnt
Loosen the CPS bolts, then bolt the caliper to the mounting
tabs. Tighten the mounting bolts to 9-10 N•m (80-90 in-lb).
Check that the caliper moves freely on the CPS hardware.
4
All manuals and user guides at all-guides.com
i.s. MoUnt
Loosen before
mounting
6.2 N•m (55 in-lb)
Rear
Remove
Mount directly
oR
diRECt MoUnt
Remove the mounting bracket but leave the CPS bolts
and washer stacks intact. Bolt the caliper directly to the
fork or frame. Snug the bolts, then back them out 1/8th to
1/4th turn. Check that the caliper moves freely on the CPS
hardware.
For larger rotor sizes, an adapter bracket may be
necessary. See Make Sure You Have The Correct
Brackets for options.
Elixir/Code User Manual
diRECt MoUnt
Snug, then back off
1/8th to 1/4th turn
95-5015-016-000 Rev F
Rear