Tilt Lock Mechanism; Tilt Support Knob; Top Cowling Lock Lever - Yamaha F30A Manuel D'utilisation

GB
EMU00154
TILT LOCK MECHANISM (for Hydro-
tilt model)
Tilt-lock mechanism is used to prevent
reverse thrust from the propeller lifting
the outboard motor when reversing. To
lock it, set the tilt-lock lever in the Lock
position. To release it, place the tilt-lock
q
lever in the Tilt position.
402063
1 Tilt-lock lever
NOTE:
The tilt-lock mechanism on the hydro-tilt
model can be used to keep the outboard
motor at a slightly tilted angle for shallow
water cruising. Refer to CRUISING IN
SHALLOW WATER for the correct opera-
tion.
EMU00155

TILT SUPPORT KNOB

To keep the outboard motor in the tilted-
up position, push the tilt support knob
under the swivel bracket.
403064
EMU00162

TOP COWLING LOCK LEVER

To remove the engine top cowling, turn
the lock lever. Then lift off the cowling.
When replacing the cowling, check to be
sure it fits properly in the rubber seal.
Then lock the cowling again by moving
q
the lever upward.
301051
1 Top cowling lock lever
2-13