Whirlpool SPIW309A3WF.1 Consignes D'utilisation page 17

Operation problems are often due to minor causes, please check and refer to the following chart before
contacting the service. This may save time and unnecessary expenses.
Trouble
Н Is the protection device or fuse blownů
Н Please wait for 3 minutes and start again, protection device may be preventing unit to work.
Does not run
Н Are the remote control batteries lowů
Н Is the plug not properly pluggedů
Н Is the air Člter dirtyů
Н Are the intakes and outlets of the air conditioner blockedů
No cooling or
heating air
Н Is the temperature set properlyů
Н Are doors or windows openů
Н Has there been a strong interference (from excessive static electricity discharge, power supply voltage
IneΑective control abnormality)ů Note that operation will be abnormal, in this case unplug from the power supply and
re-plug after 2-3 seconds.
Does not operate
Н 3 minute delay will occur when changing mode during operation.
immediately
Н This smell may come from another source such as furniture, cigarette etc, which is sucked in the unit
Peculiar smell
and blown out with the air.
Н Normal behaviour caused by the Рow of refrigerant in the air conditioner.
A sound of
running water Н Defrosting sound in heating mode.
Н The sound may be generated by the expansion or contraction of the front panel due to temperature
Cracking sound
changes.
Н Mist is present in the room with low temperatureů Normal behaviour due to cool air discharged from
Mist sprays from
the outlet
indoor unit during COOLING or DRY operation mode.
Running indicator
Рashes but indoor Н The unit is shifting from heating mode to defrost. The indicator will light oΑ and return to heating mode.
fan stops.
Note: If the problems still have, turn off the appliance and disconnect from power supply, then contact the
nearest Whirlpool Authorized Service Center. Do not attempt to move, repair, disassemble, or modify the
appliance by yourself.
-
All manuals and user guides at all-guides.com
Analysis