Whirlpool SPIW309A3WF.1 Consignes D'utilisation page 15

Main
Clean front panel of Indoor Unit
1. Disconnect from the power supply
Turn oΑ the appliance Črst before disconnecting from power supply.
2. Remove the front panel
Open the front panel as shown by the arrow (Fig. A).
Pull the slots at the side of the front panel with force to take out the front panel (Fig. B).
3. Clean the front panel
Wipe it with a soft and dry cloth. Use lukewarm water (below 40ωC) to clean if the
appliance is very dirty. After cleaning let it dry.
4. Refit and close the front panel
ReČt and close the front panel by pushing it downward.
Note:
Н Do not use substances such as gasoline or polishing powder to clean the
appliance.
Н Do not sprinkle water onto the indoor unit Dangerous! Electric shock!
Clean Air filter
It is necessary to clean the air Člter after using it for about 200 hours.Clean the air Člter
every two weeks if the air conditioner operates in an extremely dusty environment.
1. Disconnect from the power supply
Turn oΑ the appliance Črst before disconnecting from power supply.
2. Take out air filter (Fig. C).
1. Open the front panel. 2. Press the handle of the Člter gently. 3. Slide out the Člter.
3. Cleaning the air filter (Fig. D)
If the Člter is very dirty, clean it with a solution of lukewarm water and neutral
detergent.
After cleaning let it dry.
4. Refit the filter, press the filter reset button (Fig.E) at right side by using a
cylinder pin and close the front panel.
Note:
Н To avoid injury, do not touch the fins of indoor unit with your fingers
after removing the filter.
Н Do not attempt to clean the inside of the air conditioner by yourself.
Н Do not clean the filter in washing machine.
EMERGENCY OPERATION
Under emergency situation or when remote control
is missing, you can control the unit by pressing the
on/oΑ swith located on the indoor unit.
Н Turn on the appliance: when the unit is oΑ, press
this button, it will start up and operate in 6th
SENSE mode.
Н Turn oΑ the appliance: when the unit is on, press
this button, the unit will stop working.
Note: Do not press this button for a long time as it will cause malfunction.
Auto-Restart Function
If you want to set auto-restart, switch on the power supply, press the ON/OFF button on the indoor unit and hold fo
over 5 seconds, auto-restart is set with buzz sound.
If the auto-restart has been set, press the ON/OFF button on the indoor unit and hold for over 5 seconds, auto-resta
function will be cancelled with a buzz sound and air conditioner is on standby mode.
Disposal of the batteries
To protect natural resources and to promote material reuse, please separate batteries from other types of waste an
recycle them through your local, free battery return system.
All manuals and user guides at all-guides.com
- 16 -
Filter Reset button
on/oΑ switch
on/oΑ switch
Fig.A
Fig.B
Fig.C
Fig.D
Fig.E