Toto WT151M Manuel D'installation Et D'utilisation page 6

Installing the Toilet on the Carrier (continued)
3) Measure the length between the 2
markings and add 3mm. From that
dimension, mark the cutting line by
measuring from the edge opposite from
the gasket and saw off the excess.
Repeat this process for the flange pipe.
4) Bevel the cutting edges as shown.
5) Screw the tank drain outlet into the toilet
mounting stud, leaving 2-1/8" (54mm) of
the screws exposed.
6) Insert the inlet pipe and the flange pipe
into the appropriate drain holes.
7) Install the toilet bowl by aligning it with
the pipes and mounting stud. Use the
included mounting hardware to secure the
bowl.
a
a + 3mm
6
b
b + 3mm
45˚
1/2 c
c