Toto WT151M Manuel D'installation Et D'utilisation page 4

Installing the In-Wall Tank System (continued)
3) Remove the system from the wall
stud frame. Mark the centerline
of the toilet per the floor drain
location and drill a 3-1/2"
(89mm) hole in the sole plate for
the drain to pass through floor.
Attach the outlet bend to the
bracket on the carrier. Use the
lower bracket to snap the outlet
bend into place.
Position the carrier into the wall
stud frame as shown.
4) Pre-drill six 1/8" holes for
mounting the frame to the stud
wall. Use the six wood screws
to mount the carrier securely to
the wall studs, making sure the
carrier is flush with the edge of
the studs.
5) Use the remaining wood screws to secure
the mounting plate to the sole plate.
6) Add mounting lag screws (2) by screwing
each end into the inner set of PEM
in the frame. Make sure the screw is
exposed approx. 2-1/2" (63mm) past the
face of the wall stud. Insert the Foam Push
Plate Roughin and the Inlet and Outlet
Roughins.
nuts
®
4
Ø 1/8" [3mm]