Operation; Check Before Every Start-Up; Procedure In The Event Of Accidents Or Faults - Interroll RollerDrive EC5000 AI/BI Série Notice D'utilisation

Start-up and operation
6.3

Operation

Check before every start-up

Ensure that no persons are in the hazardous areas by the conveyor system.
¾
¾ Ensure that the RollerDrive is not jammed.
¾ Check the RollerDrive for any visible damage.
¾ Check all protective equipment.
Specify in detail how the material to be conveyed should be set down on the conveyor and monitor this to
¾
ensure it is carried out correctly.
Take the ambient conditions into account during operation (see „Technical specifications" on page 24).
6.4

Procedure in the event of accidents or faults

Stop the conveyor system immediately, switch off the power supply and ensure that it cannot be unintentionally
¾
switched on again.
In the event of an accident: Perform first aid and call for the emergency services.
¾
¾ Inform the relevant supervisor.
¾ Have specialist personnel rectify the fault.
¾ Only resume operating the conveyor system once this has been approved by the specialist personnel.
48 of 116
Version 2.5 (04/2020) UL
Translation of the original operating manual