Attaching The Non-Cable Side - Interroll RollerDrive EC5000 AI/BI Série Notice D'utilisation

Assembly and installation

Attaching the non-cable side

Two examples are provided:
Inserting the hexagonal spring shaft
Press the spring shaft inwards and align the shaft so that it corresponds to the opening in the side profile.
¾
Release the hexagonal spring shaft so that it springs into the opening of the side profile.
¾
Inserting the internal thread shaft pin
¾ Place a washer on a M8x20 screw.
Align the RollerDrive with the opening in the side profile and insert the M8 screw with the washer into the
¾
opening. Secure the shaft pin with an open-ended spanner to prevent it from twisting (depending on the
version of the shaft pin, the width across flats will be 13 mm or 19 mm).
42 of 116
Version 2.5 (04/2020) UL
Translation of the original operating manual