Hofmann Monty 3300 Notice D'utilisation page 26

2
26
monty 3300 / 3300AIR
4.1-3
4.1-4
4.1-5
Only for Tubeless wheel models:
F1. Press bead seater/inflator pedal (1, Fig. 4.1-3) on
left side of the machine half way down: air will come
from inflation hose end only (2, Fig. 4.1-3).
F2. Press bead-seater pedal (1, Fig.4.1-3) down swiftly
to get air blast from the turntable jets (3, Fig.4.1-3).
Note: Air simultaneously continues to exit the hose
(2, Fig. 4.1-3) connected to the tire.
WARNING: ONCE BEADING IS COMPLETE,
IMMEDIATELY STOP INTRODUCING AIR.
3
(Fig. 4.1-4)
WHEN OPERATING THE BEADING DEVICE IT IS
MANDATORY TO WEAR EAR PROTECTORS AND
SAFETY GLASSES TO PREVENT CONTAMINATION
FROM NOISE, DUST AND CHIPS BLOWN BY THE
AIR JETS.
DANGER OF TIRE EXPLOSION
Presetting of clamping jaws:
N.B.: Turntable capacity can be changed before pedal
control.
The turntable jaws can be positioned in two different
ways (Fig. 4.1-5).
Push the lever (C) on the left side of each jaw and shift
at the same each one (0/+4").
VERY IMPORTANT:
INSERTION OF THE PIN
CAUTION! MAKE SURE ALL FOUR CLAMPING JAWS
ARE MOUNTED IDENTICALLY (1 OR 2, FIG. 4.1-5).
OTHERWISE THE RIM MAY COME LOOSE AND
INJURE THE OPERATOR!
Rim diameters are shown in inches on the turntable
(A, Fig. 4.1-5). The diameter setting (mark on jaw (B)
must coincide with mark on turntable) depends on the
clamping jaw position 1 or 2.
• In jaws position 1 the diameter is preset directly
(1, Fig. 4.1-5).
• In jaws position 2 (2, Fig. 4.1-5) 4 inch must be
added to the diameter.
Operator's Manual
USA - CANADA
LOOK FOR PROPER